![cut fingers with a cheap knife cut fingers with a cheap knife](https://img.taste.com.au/V2-gHolA/w1200-h630-cfill/taste/2016/11/fish-fillets-and-mash-45772-1.jpeg)
This is where you can use your utility knife to cut through the wood unit. In order to make this job easier, put your laminate panel up against a wall, board or any flat surface that the wood end is facing out. Mark the area of the laminate panel where you want to begin and then take your utility knife and cut down through the panel.
CUT FINGERS WITH A CHEAP KNIFE HOW TO
Step By Step – How To Cut Laminate Wall Panel With A Utility Knife Tip: If you want to remove wood paneling but are afraid of tearing it or ruining its finish, spray adhesive on one side of the wood and carefully scrape along the other side with a pry tool.īelow is a Video that properly demonstrates How To Cut Wood Paneling With A Utility Knife: Once you have done this, you should have a place that is big enough for you to fit your fingers through. Once you have carved through all of the paneling, use your utility knife to carefully cut along the inside of this new cut line that was made previously. Invest in a good quality utility knife and you won’t have to deal with these problems. Too much pressure could also cause the wood to pull or break due to stress, so be cautious. If the material is not strong and solid, it could pull away from the paneling. If there are nails or screws making up part of this wood frame, carefully remove them and set them aside for later use (you can stick them back in once your cut is done).īefore you start cutting into the wood, make sure that you are careful. Before cutting, make sure that there are no nails or screws holding this part of the paneling in place. Next, using your utility knife make the cut on this line. Use a marker or tape to mark off the line for easier accuracy. You should measure out where you plan to cut from the opposite side so that it will be slightly offset when finished. Make sure that you can make the cut without causing too much of a mess. Final Thoughts on How To Cut Wood Paneling With A Utility Knife Step By Step – How To Cut Wood Paneling With A Utility Knifeįirst you have to decide where you want the cut to be made.Step By Step – How To Cut Laminate Wall Panel With A Utility Knife.Step By Step – How To Cut Wood Paneling For Outlets With A Utility Knife.Step By Step – How To Cut Wood Paneling At An Angle With A Utility Knife.Step By Step – How To Cut Wood Paneling With A Utility Knife.